Welcome, Guest. Please login or register.

Login with username, password and session length

 
Advanced search

3886 Posts in 1208 Topics- by 2247 Members - Latest Member: Steve Ahmann

May 23, 2012, 03:49:57 AM
Maintenance IssuesTR62" HS6 Stanpart inlet manifold
« previous next »
Pages: [1]   Go Down
Print
Author Topic: 2" HS6 Stanpart inlet manifold  (Read 1323 times)
r100rs
Newbie
*
Posts: 4


as time goes by
« on: September 10, 2007, 04:47:38 PM »
Hi! Is there anyone out there having tried these on a TR6? I am going for it, but will it work?  Manifold inlet has been opend 1/4" to 2". Tubular exhaust manifold as well. Needles AUD411 from a Rover 2,6 . Carbs were sold over phone as 1 3/4" an strangely grew to 2" on the wat over to my place...
Cheers R100rs
Logged
trmarty
Newbie
*
Posts: 2
« Reply #1 on: November 09, 2007, 09:11:50 PM »
Did you get any info on your post? I run HD8's on my TR6.

Marty
Logged
r100rs
Newbie
*
Posts: 4


as time goes by
« Reply #2 on: November 17, 2007, 02:03:07 PM »
No Marty!  HD8`s  from E-type Jag ? 3.4 l. Same needles?
Cheers
Logged
trmarty
Newbie
*
Posts: 2
« Reply #3 on: November 25, 2007, 08:44:15 PM »
I am running "UH" needles. I was afraid they would be too rich but they are actually pretty well matched with my current state of engine build.

Marty
Logged
Pages: [1]   Go Up
Print
« previous next »
Jump to:  

Theme orange-lt created by panic